We'll start by assembling the bottom part of the leg !
Follow the steps in order and take your time :) Snapping things in place is satisfying, not stressful !
For this step, you'll need:
| Ressource | Quantity |
|---|---|
| Round Servo Horn | 1 |
M1.4 x 5mm screws | 4 |
Printed part Leg-Bottom (R) | 1 |
Insert the Round Servo Horn into the slot at the top of the Leg-Bottom (R) part.
Make sure the small slot for the servo axle is pointing up and the horn sits flush in the recess.
Align the holes of the Leg-Bottom (R) part and the holes of the Round Servo Horn to be able to insert the screws.
Secure the servo horn with the four M1.4 x 5mm screws. Make sure to not overtighten them to avoid damaging the parts.
For this step, you'll need:
| Ressource | Quantity |
|---|---|
Contact Switch 6x6x5mm | 1 |
| Contact Switch Wire | 1 |
| TPU Printed Foot | 1 |
Feed the Contact Switch Wire from the back of the Leg-Bottom (R) part, through the hole and the internal channels, towards the Contact Switch.
Press the 6x6x5mm contact switch into the slot at the bottom of the Leg-Bottom (R) part.
Make sure the two legs of the switch are going into the Connector of the wire.
Clip the TPU Foot on the front of the Leg-Bottom (R) part.
The TPU should snap into the retaining features and sit flush.
For this step, you'll need :
| Ressource | Quantity |
|---|---|
| Plastic Clip (+ Clip Tool) | 4 |
Cover-Bottom (R) | 1 |
Cover-Bottom-Deco 1 (R) | 1 |
Cover-Bottom-Deco 2 (R) | 1 |
Insert two plastic clips into the holes of the Cover-Bottom (R) part using the Clip Tool.
Push them straight in the holes until it clips in place.
Align the Cover-Bottom (R) part with the Leg-Bottom (R) part.
Push the free ends of the plastic clips into the holes on the Leg-Bottom (R) part until they lock in place.
Push two more plastic clips in the holes of the Cover-Bottom (R) part using the Clip Tool.
Make sure to push them straight to avoid damaging the parts.
Clip the two top decorative covers (Cover-Bottom-Deco 1 (R) and Cover-Bottom-Deco 2 (R)) onto the Cover-Bottom (R) part.
They should snap into the clips and will add the final styling to the foot assembly.
Alright, let's move on to the top part then !