One of the best features of the TNY-360 is its position feedback on every one of its MG996R servomotors.
This feature is made possible by the use of a small PCB containing an operational amplifier, which outputs the position of the motor shaft as an analog voltage.
Since you're building your own TNY-360, let's see how to mod your MG996R servomotors.
We will mod your MG996R is three steps :
We'll first identify which version of the Servo Feedback Board you need to use, depending on your type of MG996R.
We'll then solder the components onto the Servo Feedback Board, and prepare it for installation.
Finally, we'll install the Servo Feedback Board inside the MG996R, and solder the new cable.