The Plastic Covers
Clip clip clip !
We'll finish the leg assembly by adding the plastic covers. Have fun snapping them in place,
and don't forget to admire your work once you're done :)
Add the Top Cover
We'll first add the top cover to the bottom cover to get a little bit more style points on this leg !
For this step, you'll need :
| Ressource | Quantity |
|---|---|
Top-Cover (R) part | 1 |
| Plastic Clips (+ Clip Tool) | 3 |
Press the Plastic Clips on the Top Cover
Use the Clip Tool to snap three Plastic Clips into the holes on the Top-Cover (R) part as shown in the video.
Make sure you push the clips straight to avoid damaging the clips or the part.
Press the Top Cover on the Bottom Cover
Now that the clips are in place, press the Top-Cover (R) part on the Bottom-Cover (R) part until it snaps in place.
Align the ends of the plastic clips with the holes on the Bottom-Cover (R) part, then push the cover straight.
Add the Decorations
Even more decorations would be too much ? Never ! Let's add the logo and the stripes to finish this leg in style :)
For this step, you'll need :
| Ressource | Quantity |
|---|---|
Cover-Logo part | 1 |
Cover-Stripe (R) part | 1 |
| Plastic Clips (+ Clip Tool) | 4 |
Press the Plastic Clips on the Logo
We'll start by adding the logo. Press two Plastic Clips into the holes of the Cover-Logo part as shown in the video.
You know the drill by now, make sure you push the clips straight to avoid damaging the clips or the part !
Press the Logo on the Top Cover
Now, press the Cover-Logo part on the Top-Cover (R) part until it snaps in place.
Press the Plastic Clips on the Stripes
Same thing for the stripes, press two Plastic Clips into the holes of the Cover-Stripe (R) part as shown in the video.
Straight push, straight push, straight push !
Press the Stripes on the Top Cover
Now add the stripes by pressing the Cover-Stripe (R) part on the Top-Cover (R) part until it snaps in place.
Add the Bottom Cover
Now that the covers are all done, we'll clip them on the leg and finish this assembly !
For this step, you'll need :
| Ressource | Quantity |
|---|---|
Bottom-Cover (R) part | 1 |
| Plastic Clips (+ Clip Tool) | 3 |
Press the Plastic Clips on the Bottom Cover
Use the Clip Tool to snap three Plastic Clips into the holes on the Bottom-Cover (R) part as shown in the video.
Make sure you push the clips straight to avoid damaging the clips or the part.
Press the Bottom Cover on the Leg Top Part
Now that the clips are in place, press the Bottom-Cover (R) part on the Leg-Top (BR) part until it sits flush.
Align the ends of the plastic clips with the holes on the Leg-Top (BR) part, then push the cover straight until it's fully seated.
Verification
Congratulations, you finished your third leg !
As for the previous ones, make sure everything is properly snapped in place, screwed in, aligned, etc.
If you notice any issues, or have any doubts about the assembly, don't hesitate to go back to verify the previous steps or ask for help on the Discord Server !
Here's how the final result should look like at this stage :
Nice ! Now that the leg is fully assembled, let's wire it up !